CNGS - EVENTS

	November 2006			CERN COURIER article on CNGS
	14 Sept. 2006			Movies on CNGS
	11 Sept. 2006			CERN press release on CNGS
	5 - 9 Sept. 2006			NBI2006 - 6th International workshop on Neutrino Beams and Instrumentation
	22 August 2006			A few events in BOREXINO
	22 August 2006			LVD start-up report
	21 August 2006			OPERA start-up report
	18 August 2006			final measurements on proton line; 14:00 - CNGS commissioning completed
	17 August 2006			further high intensity extractions; emittance measurements; TBID tests; cross-hair scans; studies of alignment in anti-neutrino mode; intensity increase in the accelerator chain
	16 August 2006			detailed extraction studies; beam loss studies; SPS damper studies; start tests with double-extraction at higher intensities
	15 August 2006			RF fine tuning in SPS; double extraction at medium intensity; adjust interlocks from beam loss and beam position monitors; horn/reflector on/off data taking; muon detector calibration
	14 August 2006			detailed proton line optics checks; start setting up double-extraction
	27 July 2006			proton line checks; target vs. horn alignment; horn+reflector timing adjusted
	26 July 2006			extraction studies; proton scan across target and collimator
	14 July 2006			proton line checks; TBID and muon monitor checks; horn+reflector polarity change to NEUTRINOS
	13 July 2006			intervention on BP electronics; proton line steering; proton scan across target; horn+reflector ON
	12 July 2006			Proton beam line: checks of all equipment
	11 July 2006			Proton beam sent through target area and decay tunnel to the hadron stopper (target out)
	10 July 2006			CNGS commisssioning started - 400 GeV/c proton beam extracted onto TED beam stopper
	29 May 2006			CNGS start with beam delayed
	19 May 2006			CNGS areas closed
	3 April 2006			Lundi Decouverte - Discovery Monday
	9 March 2006			TBID secondary beam monitor installed
	8 March 2006			Final target system installed
	3 March 2006			Horn and Reflector pulsing in final configuration
	31 January 2006			Final Horn installed in target chamber
	19 December 2005			Decay Tube window (3 mm Ti) installed
	12 December 2005			Progress of installation - December 2005
	5 December 2005			Reflector installed in target chamber
	25 November 2005			Proton beam installation completed, vacuum tested
	3 November 2005			Horn installed in target chamber (test-horn)
	21 September 2005			Last MBG deflection magnet installed
	15 August 2005			Target station progress - CERN press release
	22 July 2005			Progress of installation - July 2005
	13 July 2005			First QTG quadrupole installed in proton beam-line
	18 December 2004			50 million million protons
	17 December 2004			Progress of general services installation - 2004
	25 November 2004			New neutrino fluences available from ICARUS-FLUKA
	8 September 2004			First CNGS double batch extraction from SPS
	31 July 2004			CNGS civil engineering completed
	28-30 June 2004			3rd CNGS Review
	30 April 2004			Decay tube is leak-tight !
	7 April 2004			First horn arrived at CERN
	16 March 2004			Decay Tube installation completed
	4 February 2004			Decay Tube: Half-Way Point passed
	18 November 2003			Installation of Decay Tube started
	21 October 2003			Transport of Decay Tube Exit Flange
	2 September 2003			Hadron Stop Installation completed
	23 June 2003			Phase I Civil Engineering completed
	28-30 April 2003			2nd CNGS Review
	31 March 2003			Horn inner conductors arrived at CERN
	10 January 2003			Two MBG pre-series magnets arrived at CERN
	18 December 2002			08:45 - connection to TI_8 tunnel completed
	24 May 2002			Recuperation of iron from WANF finished
	10 April 2002			Tunnel Boring Machine removed
	14 - 19 March 2002			NBI2002 Workshop on Neutrino Beams
	18 - 20 Feb 2002			1st CNGS Review
	26 June 2001			Baptism of the Tunnel Boring Machine
	12 October 2000			CNGS ground breaking ceremony